Siemens SINUMERIK 802D sl Manual do Operador descarregar pdf (Página 58)

Overview of alarms 06/2009

NCK alarms

2-58

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Remedy: Use another tool.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10790 [Channel %1: ] Block %2 plane change during linear programming with

angles

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The active plane was changed between the first and second subblock when programming two straight

lines with angle parameters.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10791 [Channel %1: ] Block %2 invalid angle during linear programming

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: No intermediate point was found when programming a contour consisting of two straight lines and an

angle specification.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10792 [Channel %1: ] Block %2 illegal interpolation type during linear

programming with angles

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Only spline or linear interpolation is permitted for programming two straight lines with angle specifica-

tion. Circular or polynomial interpolation is not allowed.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10793 [Channel %1: ] Block %2 second block missing during linear

programming with angles

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The second block is missing during programming of two straight lines with angle specification. This

situation only occurs if the first subblock is also the last block of a program, or if the first subblock is

followed by a block with a preprocessor stop.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 339 340

Comentários a estes Manuais

Sem comentários

Siemens SINUMERIK 802D sl Manual do Operador Página 58

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Siemens SINUMERIK 802D sl