Siemens SINUMERIK 802D sl Manual do Operador descarregar pdf (Página 46)

Overview of alarms 06/2009

NCK alarms

2-46

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

10653 [Channel %1: ] Axis %2 gantry error threshold exceeded

Parameters: %1 = Channel number

%2 = Axis

Definitions: The gantry following axis has exceeded the error limit (actual value tolerance) specified in MD37120

$MA_GANTRY_POS_TOL_ERROR.

Reaction: NC Start disable in this channel.

Interface signals are set.

Alarm display.

NC Stop on alarm.

Remedy: Please inform the authorized personnel/service department.

1. Check axis (uneven mechanical movement?)

2. MD not set correctly (MD37120 $MA_GANTRY_POS_TOL_ERROR). A POWER ON is necessary

after modifying the MD.

If the axes are not yet referenced, MD37130 $MA_GANTRY_POS_TOL_REF is the trigger condition

for the error message.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

10654 [Channel %1: ] Waiting for synchronization start of gantry group %2

Parameters: %1 = Channel number

%2 = Gantry unit

Definitions: The alarm message appears when the axes are ready for synchronization. The gantry grouping can

now be synchronized. The actual value difference between the master and slave axes is greater than

the gantry warning limit MD 37110 $MA_GANTRY_POS_TOL_WARNING. The synchronization must

be started explicitly with the NC/PLC interface signal <StartSynchronisationGantry/> (Start gantry syn-

chronization).

Reaction: Alarm display.

Remedy: Please inform the authorized personnel/service department.

See Function Manual, Special Functions, Gantry Axes (G1)

Program Con-

tinuation:

Alarm display showing cause of alarm disappears. No further operator action necessary.

10655 [Channel %1: ] Synchronization of gantry group %2 in progress

Parameters: %1 = Channel number

%2 = Gantry unit

Definitions: No further explanation.

Reaction: Alarm display.

Remedy: --

Program Con-

tinuation:

Alarm display showing cause of alarm disappears. No further operator action necessary.

10656 [Channel %1: ] Axis %2 gantry slave axis dynamically overloaded

Parameters: %1 = Channel number

%2 = Axis

Definitions: The indicated gantry slave axis is dynamically overloaded, i.e. the slave axis cannot follow the master

axis dynamically

Reaction: Mode group not ready.

Local alarm reaction.

Channel not ready.

Interface signals are set.

Alarm display.

Remedy: Please inform the authorized personnel/service department. Compare the axial machine data of the

gantry slave axis with the data of the gantry master axis

Program Con-

tinuation:

Clear alarm with the RESET key in all channels of this mode group. Restart part program.

10657 [Channel %1: ] Axis %2 power OFF in the gantry error limit exceeded

status

Parameters: %1 = Channel number

%2 = Axis

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 339 340

Comentários a estes Manuais

Sem comentários

Siemens SINUMERIK 802D sl Manual do Operador Página 46

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Siemens SINUMERIK 802D sl