Siemens SINUMERIK 802D sl Manual do Operador Página 107

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 340
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 106
NCK alarms
06/2009 Overview of alarms
2-107
© Siemens AG 2009 All Rights Reserved
SINUMERIK 802D sl, Diagnostics Manual, 06/2009
Definitions: An assignment change of the geometry axes to channel axes is not permitted with active tangential
control.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Change part program and delete active tangential control with TANGDEL.
Program Con-
tinuation:
Clear alarm with NC START or RESET key and continue the program.
14430 [Channel %1: ] Block %2 tangential axis %3 must not be traversed as
POS axis
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name
Definitions: A tangentially followed-up axis cannot be traversed as positioning axis.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Change part program and delete active tangential control with TANGDEL.
Program Con-
tinuation:
Clear alarm with NC START or RESET key and continue the program.
14432 [Channel %1: ] Block %2 rounding length for tangential axis %3 is zero.
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name
Definitions: For a tangential axis that is coupled during preparation, a rounding length must be indicated with
TANGON() on activating the tangential control, or possibly occuring discontinuities of the tangential
axis cannot be smoothed.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program
Program Con-
tinuation:
Clear alarm with NC START or RESET key and continue the program.
14434 [Channel %1: ] Block %2 rel. lift-off path for tangential axis %3 is invalid
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name
Definitions: Factor r as programmed on TLIFT for the relative lift-off path must be within range 0 =< r < 1.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program
Program Con-
tinuation:
Clear alarm with NC START or RESET key and continue the program.
14500 [Channel %1: ] Block %2 illegal DEF or PROC instruction in the part
program
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: NC part programs with high-level language elements are divided into a preceding definition part fol-
lowed by a program part. The transition is not marked specifically; a definition statement is not allowed
to follow the 1st program command.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Put definition and PROFC statements at the beginning of the program.
Vista de página 106
1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 339 340

Comentários a estes Manuais

Sem comentários