Siemens SINUMERIK 802D sl Manual do Operador descarregar pdf (Página 261)

Cycle alarms

06/2009 Overview of alarms

2-261

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Alarm display.

Remedy: --

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61805 [Channel %1: ] Block %2: Value programmed absolute and incremental

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The programmed intermediate position is both absolutely as well as incrementally programmed.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: --

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61806 [Channel %1: ] Block %2: Wrong axis assignment

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The axis-assignment sequence is wrong.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: --

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61807 [Channel %1: ] Block %2: Wrong spindle direction programmed (active)

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycle: CYCLE840.

The programmed spindle direction contradicts the spindle direction planned for the cycle.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check parameters SDR and SDAC.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61808 [Channel %1: ] Block %2: Final drilling depth or single drilling depth

missing

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The total depth Z or individual drilling depth Q is missing from theG8xblock (initial cycle call).

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: --

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61809 [Channel %1: ] Block %2: Drill position not permissible

Parameters: %1 = Channel number

%2 = Block number, label

1 2 ... 256 257 258 259 260 261 262 263 264 265 266 ... 339 340

Comentários a estes Manuais

Sem comentários

Siemens SINUMERIK 802D sl Manual do Operador Página 261

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Siemens SINUMERIK 802D sl