Siemens SINUMERIK 802D sl Manual do Operador descarregar pdf (Página 101)

NCK alarms

06/2009 Overview of alarms

2-101

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

14170 [Channel %1: ] Block %2 illegal interpolation type with tool length

compensation

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: If tool compensation (G43/G44) is activated in language mode ISO_M, the linear type of interpolation

must be active.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14180 [Channel %1: ] Block %2 H number %3 is not defined

Parameters: %1 = Channel number

%2 = Block number, label

%3 = H number of ISO mode

Definitions: The specified H number is not assigned to a tool (ISO_M).

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14185 [Channel %1: ] Block %2 D number %3 is not defined

Parameters: %1 = Channel number

%2 = Block number, label

%3 = D number of ISO mode

Definitions: The specified D number is not assigned to a tool (language mode ISO_M).

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14197 [Channel %1: ] Block %2 D number and H number programmed

simultaneously

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: A D word and H word have been programmed simultaneously.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

14198 [Channel %1: ] Block %2 illegal change of tool direction with tool offset

Parameters: %1 = Channel number

%2 = Block number, label

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 339 340

Comentários a estes Manuais

Sem comentários

Siemens SINUMERIK 802D sl Manual do Operador Página 101

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Siemens SINUMERIK 802D sl