Siemens SINUMERIK 802D sl Manual do Operador descarregar pdf (Página 226)

Overview of alarms 06/2009

Cycle alarms

2-226

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Alarm triggered by following cycle: CYCLE61

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Select another direction of machining.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61267 [Channel %1: ] Block %2: Plane infeed too large, residual corners remain

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: In face milling, the plane infeed must not exceed 85%.

Alarm triggered by following cycle: CYCLE61

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Select a smaller plane infeed, as otherwise residual corners will be left over.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61268 [Channel %1: ] Block %2: Illegal machining direction, residual corners

are left over.

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: In face milling, the machining direction does not match the selected delimitations.

Alarm triggered by following cycle: CYCLE61.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: The machining direction must be selected to match the delimitations.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61269 [Channel %1: ] Block %2: External tool diameter too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Incorrect tool definition.

Alarm triggered by following cycle: CYCLE61.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check angle and diameter of the tool used.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61270 [Channel %1: ] Block %2: Chamfer width too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Chamfer width selected too small.

Alarm triggered by the following cycles: E_SP_CHA, F_SP_CHA.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Increase the chamfer width.

1 2 ... 221 222 223 224 225 226 227 228 229 230 231 ... 339 340

Comentários a estes Manuais

Sem comentários

Siemens SINUMERIK 802D sl Manual do Operador Página 226

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Siemens SINUMERIK 802D sl