Siemens SINUMERIK 802D sl Manual do Operador descarregar pdf (Página 221)

Cycle alarms

06/2009 Overview of alarms

2-221

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

61244 [Channel %1: ] Block %2: Pitch change causing

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The specified pitch change causes a reversal of the thread direction.

Alarm triggered by following cycle: CYCLE99

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check pitch change and thread geometry.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61245 [Channel %1: ] Block %2: Machining plane does not match modal

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Machining plane does not match modal one.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check the machining plane.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61246 [Channel %1: ] Block %2: Safety distance too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The safety clearance is too small for machining.

Alarm triggered by following cycle: CYCLE79.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Increase safety clearance.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61247 [Channel %1: ] Block %2: Blank radius too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The blank radius is too small for machining.

Alarm triggered by following cycle: CYCLE79.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Increase blank radius.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61248 [Channel %1: ] Block %2: Infeed too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The infeed is too small for machining.

Alarm triggered by following cycle: CYCLE79.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

1 2 ... 216 217 218 219 220 221 222 223 224 225 226 ... 339 340

Comentários a estes Manuais

Sem comentários

Siemens SINUMERIK 802D sl Manual do Operador Página 221

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Siemens SINUMERIK 802D sl