Siemens SINUMERIK 802D sl Manual do Operador descarregar pdf (Página 218)

Overview of alarms 06/2009

Cycle alarms

2-218

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

61225 [Channel %1: ] Block %2: Swivel data record unknown

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: An attempt was made to access a swivel data block which has not been defined.

Alarm triggered by following cycles: E_TCARR, F_TCARR.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Select another swivel data block or define a new swivel data block.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61226 [Channel %1: ] Block %2: Inclinable head cannot be exchanged

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The parameter "Swivel data block" is set to "No". In spite of this, an attempt has been made to change

the swivel head.

Alarm triggered by following functions: E_TCARR, F_TCARR.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Set the parameter "Swivel data block" in the start-up screen "Rotary axes" to "Automatic" or "Manual".

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61230 [Channel %1: ] Block %2: Tool probe diameter too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The tool probe has not been calibrated correctly.

Alarm triggered by following cycles: E_MT_CAL, E_MT_RAD, E_MT_LEN.

Remedy: Correct variable E_MESS_MT_DR[n] or E_MESS_MT_DL[n] for tool probe n+1 in data block GUD7

(measuring in JOG).

61231 [Channel %1: ] Block %2: ShopMill program %4 not executable, as not

tested by ShopMill

Parameters: %1 = Channel number

%2 = Block number, label

%4 = Program name

Definitions: Before a ShopMill program can be executed, it has to be tested by ShopMill.

Alarm triggered by following cycle: E_HEAD.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: The program has to be simulated first in ShopMill or loaded into the operating mode "Machine auto"

by ShopMill.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61232 [Channel %1: ] Block %2: Impossible to load magazine tool

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Only manual tools may be loaded into a swivel head in which only manual tools can be loaded.

The alarm is triggered by the following cycles: E_TD, E_TFS, F_TFS

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

1 2 ... 213 214 215 216 217 218 219 220 221 222 223 ... 339 340

Comentários a estes Manuais

Sem comentários

Siemens SINUMERIK 802D sl Manual do Operador Página 218

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Siemens SINUMERIK 802D sl