Siemens SINUMERIK 802D sl Manual do Operador descarregar pdf (Página 304)

100

101

List of action numbers 06/2009

3-304

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

No. 69, PROGESTON

No. 70, PROGESTOFF

No. 71, STOPATIPOBUFFER_ISEMPTY_ALARM

No. 72, STOPATIPOBUF_EMPTY_ALARM_REORG

No. 73, CONDITIONAL_STOPATEND

Explanation Activate program test (VDI signal: Program test).

Cause 1. Tool management is active

2. The NCK channel is in a state other than "ready"

Remedy − Backing up tool data

− Abort the program or process with the Reset key or

− wait for end of program

Explanation Deactivate program test (VDI signal: Program test).

Cause The NCK channel is in a state other than "ready"

Remedy − Abort the program or process with the Reset key or

− wait for end of program

Explanation Stop at the end of block preparation (alarm)

Cause -

Remedy -

Explanation Stop at the end of block preparation with subsequent reorganization of block processing

(alarm)

Cause Nesting depth too great

Remedy − Wait until the preceding ASUB is complete or

− Abort program

Explanation Conditional stop at block end. If, after continuation by means of an NC Start, there is still

a reason to stop "Stop at block end", the program stops again.

Cause -

Remedy -

1 2 ... 299 300 301 302 303 304 305 306 307 308 309 ... 339 340

Comentários a estes Manuais

Sem comentários

Siemens SINUMERIK 802D sl Manual do Operador Página 304

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Siemens SINUMERIK 802D sl