Siemens SINUMERIK 802D sl Manual do Operador descarregar pdf (Página 246)

Overview of alarms 06/2009

Cycle alarms

2-246

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Remedy: A tool offset value has to be programmed

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61504 [Channel %1: ] Block %2: _KNG incorrect for setup

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycle: setup function

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61505 [Channel %1: ] Block %2: retraction path < 1mm

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycle: CYCLE420

Remedy: Increase retraction path

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61506 [Channel %1: ] Block %2: infeed path < 1mm

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycle: CYCLE420

Remedy: Increase infeed path

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61507 [Channel %1: ] Block %2: safety clearance < 1mm

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycle: setup function

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61508 [Channel %1: ] Block %2: Incorrect default setting for shoulder position

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycle: setup function

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61509 [Channel %1: ] Block %2: Incorrect default setting for dresser position

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycle: setup function

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61510 [Channel %1: ] Block %2: Test run feed is active

Parameters: %1 = Channel number

%2 = Block number, label channel number

Definitions: The alarm can be triggered by the following grinding cycles: CYCLE410, CYCLE411, CYCLE413,

CYCLE415, CYCLE420

Remedy: Switch off test run feed

1 2 ... 241 242 243 244 245 246 247 248 249 250 251 ... 339 340

Comentários a estes Manuais

Sem comentários

Siemens SINUMERIK 802D sl Manual do Operador Página 246

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Siemens SINUMERIK 802D sl