Siemens SINUMERIK 802D sl Manual do Operador descarregar pdf (Página 216)

Overview of alarms 06/2009

Cycle alarms

2-216

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

61216 [Channel %1: ] Block %2: Feed/tooth only possible with cutting tools

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Feed per tooth is only possible with milling tools.

Alarm triggered by following cycles: E_TFS, F_TFS.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: As alternative, set a different feed type.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61217 [Channel %1: ] Block %2: Cutting speed programmed for tool radius 0

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: To be able to work with cutting speed, the tool radius has to be specified.

Alarm triggered by following cycles: E_DR_SIN, E_DR_TAP, E_TFS, F_DR_SIN, F_DR_TAP,

F_DRILLC, F_DRM_TA, F_TAP, F_TFS

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Enter a value for cutting speed.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61218 [Channel %1: ] Block %2: Feed/tooth programmed, but number of tools

equals zero

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: For feed per tooth, the number of teeth has to be specified.

Alarm triggered by following cycles: E_TFS, E_DR_BGF, F_TFS.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Enter the number of teeth on the milling tool in the "Tool list" menu.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61219 [Channel %1: ] Block %2: Tool radius too large

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The tool radius is too large for machining.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Select a suitable tool.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61220 [Channel %1: ] Block %2: Tool radius too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The tool radius is too small for machining.

Alarm triggered by following cycles: CYCLE78.

Reaction: Interpreter stop

1 2 ... 211 212 213 214 215 216 217 218 219 220 221 ... 339 340

Comentários a estes Manuais

Sem comentários

Siemens SINUMERIK 802D sl Manual do Operador Página 216

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Siemens SINUMERIK 802D sl