Siemens SINUMERIK 802D sl Manual do Operador descarregar pdf (Página 217)

Cycle alarms

06/2009 Overview of alarms

2-217

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Select a suitable tool.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61221 [Channel %1: ] Block %2: No tool active

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: No tool active.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Select a suitable tool.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61222 [Channel %1: ] Block %2: Plane infeed greater than tool diameter

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The plane infeed must not be greater than the tool diameter.

Alarm triggered by following cycles: CYCLE79, , E_MI_PL, E_PO_CIR, E_PO_REC, F_PO_CIR,

F_PO_REC.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Reduce plane infeed.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61223 [Channel %1: ] Block %2: Approach path too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The approach path must not be less than zero.

Alarm triggered by following cycles: E_MI_CON, F_MI_CON.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Enter a greater value for the approach path.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61224 [Channel %1: ] Block %2: Retract path too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The retract path must not be less than zero.

Alarm triggered by following cycles: E_MI_CON, F_MI_CON.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Enter a greater value for the retract path.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 212 213 214 215 216 217 218 219 220 221 222 ... 339 340

Comentários a estes Manuais

Sem comentários

Siemens SINUMERIK 802D sl Manual do Operador Página 217

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Siemens SINUMERIK 802D sl