Siemens SINUMERIK 802D sl Manual do Operador descarregar pdf (Página 266)

Overview of alarms 06/2009

Cycle alarms

2-266

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.

Remedy: --

61980 [Channel %1: ] Block %2: Error in the island contour

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.

Remedy: --

61981 [Channel %1: ] Block %2: Error in the edge contour

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.

Remedy: --

61982 [Channel %1: ] Block %2: Infeed width in the plane too large

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.

Remedy: --

61983 [Channel %1: ] Block %2: Pocket edge contour missing

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.

Remedy: --

61984 [Channel %1: ] Block %2: Tool parameter _TN not defined

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.

Remedy: --

61985 [Channel %1: ] Block %2: Program name for drilling positions missing

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.

Remedy: --

61986 [Channel %1: ] Block %2: Program pocket milling missing

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.

Remedy: --

61987 [Channel %1: ] Block %2: Program drilling positions missing

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.

Remedy: --

61988 [Channel %1: ] Block %2: Program name for pocket milling missing

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Alarm triggered by following cycles: CYCLE73, CYCLE74, CYCLE75.

Remedy: --

1 2 ... 261 262 263 264 265 266 267 268 269 270 271 ... 339 340

Comentários a estes Manuais

Sem comentários

Siemens SINUMERIK 802D sl Manual do Operador Página 266

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Siemens SINUMERIK 802D sl