Siemens SINUMERIK 802D sl Manual do Operador descarregar pdf (Página 124)

Overview of alarms 06/2009

NCK alarms

2-124

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

Remedy: Include a probe number within the limits given above in the keyword MEAW=... This must correspond

to the hardware connection of the probe.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

15950 [Channel %1: ] Block %2 no traverse motion programmed

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Measure with deletion of distance-to-go

In the part program, no axis or a traversing path of zero has been programmed with the command

MEAS (measure with deletion of distance-to-go).

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Correct the part program and add the axis address or the traversing path to the measurements block.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

15960 [Channel %1: ] Block %2 no traverse motion programmed

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Measure without deletion of distance-to-go

In the part program, no axis or a traversing path of zero has been programmed with the command

MEAW (measure without deletion of distance-to-go).

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Correct the part program and add the axis address or the traversing path to the measurements block.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16020 [Channel %1: ] Repositioning in block %2 is not possible

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Programming or operator action incorrect:

Repositioning via REPOS command is only possible in an asynchronous subprogram (interrupt rou-

tine).

If the REPOS command was programmed, e.g. in the main program or in a cycle, part program exe-

cution is aborted with alarm 16020.

In addition, the alarm is output in the following situations:

- Access to $AC_RETPOINT (repositioning point) outside an ASUP (e.g. in the main program)

- An axis to be repositioned was a oscillating axis with sychronous infeed (OSCILL) in the interrupted

block and is now in a state that does not allow it to be traversed as a oscillating axis. Remedy: Change

the axis to "neutral axis" state before repositioning with WAITP.

- An axis to be repositioned was an infeed axis for a oscillating axis in the interrupted block; now it can

no longer be traversed as one. Remedy: Change the axis back to "POS axis" state before reposition-

ing.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Modify the part program if necessary.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

16100 [Channel %1: ] Block %2 spindle %3 not available in the channel

Parameters: %1 = Channel number

%2 = Block number, label

%3 = String

Definitions: Incorrect programming:

This channel does not recognize the spindle number.

1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 339 340

Comentários a estes Manuais

Sem comentários

Siemens SINUMERIK 802D sl Manual do Operador Página 124

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Siemens SINUMERIK 802D sl