Siemens SINUMERIK 802D sl Manual do Operador descarregar pdf (Página 225)

Cycle alarms

06/2009 Overview of alarms

2-225

SINUMERIK 802D sl, Diagnostics Manual, 06/2009

61262 [Channel %1: ] Block %2: pitch not possible with selected tool

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The pitch of the tap does not match the programmed pitch.

Alarm triggered by following cycles: F_DR_TAP, F_DRM_TA, F_TAP.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Use a tap with the programmed pitch.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61263 [Channel %1: ] Block %2: Chained ShopMill program blocks not

permissible in subprogram on pos. pattern

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: If a subroutine is called from a position pattern, the subroutine itself must not include a position pattern.

The alarm is triggered by the following cycle: E_MANAGE

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Reprogram machining.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61264 [Channel %1: ] Block %2: Chained ShopTurn program blocks not

permissible in subprogram on pos. pattern

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: If a subroutine is called from a position pattern, the subroutine itself must not include a position pattern.

Alarm triggered by following cycle: F_MANAGE.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Reprogram machining.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61265 [Channel %1: ] Block %2: Too many restrictions, use rectangular pocket

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: In face milling a maximum of only 3 sides can be delimited.

Alarm triggered by following cycle: CYCLE61

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Use pocket cycle.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61266 [Channel %1: ] Block %2: Illegal machining direction

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: In face milling, the delimitations and the direction of machining do not match.

1 2 ... 220 221 222 223 224 225 226 227 228 229 230 ... 339 340

Comentários a estes Manuais

Sem comentários

Siemens SINUMERIK 802D sl Manual do Operador Página 225

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Siemens SINUMERIK 802D sl