Siemens HydroRanger 200 Manual de Instruções descarregar pdf (Página 29)

7ML19981FC01 HydroRanger 200 – INSTRUCTION MANUAL Page 15

mmmmm

Wiring

Level System Synchronization

When using multiple ultrasonic level monitors, be sure to run the transducer cables in

separate grounded metal conduits.

When separate conduits are not possible, synchronize the level monitors so that no unit

transmits while another is waiting for echo reception.

Synchronizing with another HydroRanger 200 or other Milltronics instru-

ments (DPL+, SPL, XPL+, Hydro+, EnviroRanger, MiniRanger, MultiRanger

100/200):

• Mount the level monitors together in one cabinet

• Use a common power (mains) supply and ground (earth) for all units

• Interconnect the SYNC terminals of all level monitors

• Contact Siemens Milltronics or your local distributor. See www.milltronics.com.

Power

Note: The HydroRanger 200 CANNOT be synchronized with the MultiRanger Plus or

the HydroRanger.

HydroRanger

Other Siemens

Important!

Before applying power to the HydroRanger 200 for the first time, ensure any

connected alarm/control equipment is disabled until satisfactory system operation

and performance is verified.

Notes for AC power connections

• The equipment must be protected by a 15 A fuse, or circuit breaker in the

building installation.

• A circuit breaker or switch in the building installation, marked as the disconnect

switch, must be in close proximity to the equipment and within easy reach of the

operator.

L2/N

GND

Note: Make sure unit is

connected to a

reliable ground.

Ground

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 255 256

Sem comentários

Siemens HydroRanger 200 Manual de Instruções Página 29