Siemens SINUMERIK 802D sl Especificações descarregar pdf (Página 81)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-81

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

Remedy: Enter the name of the facing axis in MD 20100 DIAMETER_AX_DEF for the spindles used.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10880 Channel %1 block %2 too many empty blocks between two traversing

blocks when inserting chamfers or radii

Parameters: %1 = channel number

%2 = block number, label

Definitions: Between 2 blocks containing the contour elements and to be joined with a chamfer or a radius (CHF,

RND), too many dummy blocks have been programmed without contour information.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

Remedy: Modify the part program so that the maximum permissible number of empty blocks is not exceeded.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10881 Channel %1 block %2 overflow of local block buffer when inserting

chamfers or radii

Parameters: %1 = channel number

%2 = block number, label

Definitions: Between 2 blocks containing the contour elements and to be joined with a chamfer or a radius (CHF,

RND), so many dummy blocks have been programmed without contour information that the internal

buffer is too small.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

Remedy: Modify the part program so that number of empty blocks is reduced.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10882 Channel %1 block %2 activation of chamfers or radii (non-modal) without

traversing movement in the block

Parameters: %1 = channel number

%2 = block number, label

Definitions: No chamfer or radius has been inserted between 2 linear or circle contours (edge breaking) because:

There is no straight line or circle contour in the plane.

There is a movement outside of the plane.

A plane change has taken place.

The maximum permissible number of empty blocks with traversing information (dummy blocks) has

been exceeded.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

Remedy: Correct the part program according to the error described above.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 391 392

Siemens SINUMERIK 802D sl Especificações Página 81

Comentários a estes Manuais

Siemens SINUMERIK 802D sl Especificações Página 81

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Siemens SINUMERIK 802D sl