Siemens SINUMERIK 802D sl Especificações descarregar pdf (Página 302)

Overview of alarms 06/2007

Cycle alarms

2-302

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

61273 Channel %1 block %2: Insertion depth too large

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Insertion depth on chamfering too large.

Alarm triggered by following cycles: E_SP_CHA, F_SP_CHA.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Decrease the insertion depth.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61274 Channel %1 block %2: Invalid tool angle

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Invalid tool angle.

Alarm triggered by following cycles: E_SP_CHA, F_SP_CHA.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Check tool angle.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61275 Channel %1 block %2: Target point violates software limit switch!

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Due to a swivel action, the end point is outside the software limit switches.

Alarm triggered by following cycle: E_SP_RP.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Select another retraction plane or approach a suitable interpolation point.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61276 Channel %1 block %2: External tool diameter required for restrictions

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Outer tool diameter required in case of delimitations.

Alarm triggered by following cycle: CYCLE61.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Specify the outer tool diameter.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61277 Channel %1 block %2: Tool diameter larger than restriction

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Tool diameter larger than delimitation.

Alarm triggered by following cycle: CYCLE61.

Reaction: Interpreter stop

1 2 ... 297 298 299 300 301 302 303 304 305 306 307 ... 391 392

Comentários a estes Manuais

Sem comentários

Siemens SINUMERIK 802D sl Especificações Página 302

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Siemens SINUMERIK 802D sl