Siemens SINUMERIK 802D sl Especificações descarregar pdf (Página 35)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-35

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

4345 Channel %1 invalid configuration in chained transformation no. %2

Parameters: %1 = Channel number

%2 = Transformation number

Definitions: A chained transformation is incorrectly configured (machine data $MC_TRACON_CHAIN_1 or

$MC_TRACON_CHAIN_2). The following causes for the error are possible:

- The list of transformations to be chained starts with a 0 (at least one entry not equal to zero is

required).

- The list of transformations to be chained contains the number of a transformation which does not

exist.

- The number of a transformation in the list is greater than or equal to the number of the chained trans-

formation. Example: The cascaded transformation is the fourth transformation in the system, i.e.

$MC_TRAFO_TYPE_4 = 8192. In this case, only values 1, 2 or 3 may be entered in the associated

list (e.g. $MC_TRACON_CHAIN_1[...]).

- The chaining setting is invalid. The following restrictions currently apply. A maximum of two transfor-

mations can be chained. The first transformation must be an orientation transformation, transmit,

peripheral curve transformation or inclined axis. The second transformation must be the inclined axis

transformation.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Set a valid transformation chain.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

4346 Channel %1 invalid geoaxis assignment in machine data %2[%3]

Parameters: %1 = channel number

%2 = name of machine data

%3 = transformation number

Definitions: Machine data TRAFO_GEOAX_ASSIGN_TAB_1/2 contains an invalid entry.

The following causes for the error are possible:

- The entry references a channel axis that does not exist.

- The entry is zero (no axis) but the transformation needs the relevant axis as

a channel axis.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Correct the entry in TRAFO_GEOAX_ASSIGN_TAB_1/2 or TRAFO_AXES_IN_1/2.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

4347 Channel %1 invalid channel axis assignment in machine data %2[%3]

Parameters: %1 = channel number

%2 = name of the machine data

%3 = transformation number

Definitions: Machine data TRAFO_AXIS_IN_1/2 contains an invalid entry.

The following causes for the error are possible:

- The entry references a channel axis which does not exist.

- The entry is zero (no axis) but the transformation needs the relevant axis as a channel axis.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Correct the entry in TRAFO_AXES_IN_1/2.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 391 392

Comentários a estes Manuais

Sem comentários

Siemens SINUMERIK 802D sl Especificações Página 35

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Siemens SINUMERIK 802D sl