Siemens SINUMERIK 802D sl Especificações descarregar pdf (Página 202)

Overview of alarms 06/2007

NCK alarms/ISO alarms

2-202

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

Definitions: No more than the specified number of outputs may be programmed in an NC block.

The quantity of hardware outputs is defined in the MD:

10360 FASTIO_DIG_NUM_OUTPUTS and

10310 FASTIO_ANA_NUM_OUTPUTS

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Program fewer digital/analog outputs in one block. The specified maximum number applies in each

case separately for analog or digital outputs. If necessary, program two NC blocks.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

17160 Channel %1 block %2 no tool selected

Parameters: %1 = channel number

%2 = block number, label

Definitions: An attempt has been made to access the current tool offset data although no tool was selected before-

hand.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Program or activate a tool offset in the NC part program.

Example:

N100 G.. ... T5 D1 ... LF

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

17170 Channel %1 block %2 number of symbols too large

Parameters: %1 = channel number

%2 = block number, label

Definitions: The predefined symbols could not be read in during power-up.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: - SYSTEM ERROR – Please inform the authorized personnel/service department.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

17180 Channel %1 block %2 illegal D number

Parameters: %1 = channel number

%2 = block number, label

Definitions: In the displayed block, access is made to a D number (tool edge number) that is not initialized and

therefore is not available.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Check tool call in the NC part program:

Correct tool edge number D.. programmed?

If no tool edge number is specified, then D1 is automatically active.

All tool parameters defined?

The dimensions of the tool edge must have been entered previously either on the operator panel or

via the RS-232-C interface.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

1 2 ... 197 198 199 200 201 202 203 204 205 206 207 ... 391 392

Siemens SINUMERIK 802D sl Especificações Página 202

Comentários a estes Manuais

Siemens SINUMERIK 802D sl Especificações Página 202

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Siemens SINUMERIK 802D sl