Siemens SINUMERIK 802D sl Especificações descarregar pdf (Página 315)

Cycle alarms

06/2007 Overview of alarms

2-315

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

61603 Channel %1 block %2: Recess type incorrectly defined

Parameters:

Definitions: Source (cycle):

CYCLE93

CYCLE374T

Remedy: ( Radii/chamfers at the groove base do not match the groove width

(Face groove on a contour element running parallel to the longitudinal

axis is not possible.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61604 Channel %1 block %2: Active tool violates programmed contour

Parameters:

Definitions: Source (cycle):

CYCLE95

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Contour violation in relief cut elements caused by the tool clearance angle of the tool used, i.e. use

another tool or check sub-contour program.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61605 Channel %1 block %2: Contour incorrectly programmed

Parameters:

Definitions: Source (cycle):

CYCLE95

Remedy: Impermissible relief cut element detected

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61606 Channel %1 block %2: Error during contour preparation

Parameters:

Definitions: Source (cycle):

CYCLE95

Remedy: Check sub-contour program

This alarm is always triggered in conjunction with a 10930 ... 10934, 15800 or 15810 NCK alarm.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61607 Channel %1 block %2: Starting point incorrectly programmed

Parameters:

Definitions: Source (cycle):

CYCLE95

CYCLE376T

Remedy: The starting point reached before the cycle call does not lie outside the rectangle described by the

contour subroutine.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61608 Channel %1 block %2: Incorrect tool point direction programmed

Parameters:

Definitions: Source (cycle):

CYCLE94

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

1 2 ... 310 311 312 313 314 315 316 317 318 319 320 ... 391 392

Comentários a estes Manuais

Sem comentários

Siemens SINUMERIK 802D sl Especificações Página 315

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Siemens SINUMERIK 802D sl