Siemens SINUMERIK 802D sl Especificações descarregar pdf (Página 77)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-77

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

10784 Channel %1 block %2 illegal tool for tool radius compensation with

constraint surface

Parameters: %1 = channel number

%2 = block number, label

Definitions: When activating the tool radius compensation with constraint surface, an illegal tool type is active.

Only cutting tools of the tool types 1 to 399 are admitted with the following exceptions:

• 111 ball end milling cutter

• 155 Bevel cutter

• 156 Bevel cutter

• 157 Bevel cutter

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Use a different tool.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10790 Channel %1 block %2 plane change during linear programming with

angles

Parameters: %1 = channel number

%2 = block number, label

Definitions: The active plane was changed between the first and second subblock when programming two straight

lines with angle parameters.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Modify part program

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10791 Channel %1 block %2 invalid angle during linear programming

Parameters: %1 = channel number

%2 = block number, label

Definitions: No intermediate point was found when programming a contour consisting of two straight lines and an

angle specification.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

10792 Channel %1 block %2 illegal interpolation type during linear

programming with angles

Parameters: %1 = channel number

%2 = block number, label

Definitions: Only spline or linear interpolation is permitted for programming two straight lines with angle specifica-

tion. Circular or polynomial interpolation is not allowed.

Reaction: Correction block is reorganized.

Local alarm reaction.

Interface signals are set.

Alarm display.

NC Stop on alarm at block end.

Remedy: Modify part program.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 391 392

Siemens SINUMERIK 802D sl Especificações Página 77

Comentários a estes Manuais

Siemens SINUMERIK 802D sl Especificações Página 77

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Siemens SINUMERIK 802D sl