Siemens SINUMERIK 802D sl Especificações descarregar pdf (Página 182)

Overview of alarms 06/2007

NCK alarms/ISO alarms

2-182

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

Definitions: The specified axis is a slave axis in a transformation grouping. When the coupling is switched on, the

transformation cannot be changed to another one.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Modify part program. Switch off coupling(s) of this axis before changing transformation or do not

change the transformation.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16795 Channel %1 block %2 string cannot be interpreted

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: A coupling has been switched on in which a non-interpretable string has been written (e.g. block

change behavior).

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16797 Channel %1 block %2 coupling is active

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: An operation is to be performed in which no coupling may be active, e.g. COUPDEL or TANGDEL

must not be used on active couplings.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Correct NC part program, deselect the link with COUPOF or TANGOF.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16800 Channel %1 block %2 traverse instruction DC/CDC for axis %3 not

allowed

Parameters: %1 = channel number

%2 = block number, label

%3 = axis name, spindle number

Definitions: The vocabulary word DC (Direct Coordinate) can only be used for rotary axes. This causes approach

of the programmed absolute position along the shortest path.

Example:

N100 C=DC(315)

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Please inform the authorized personnel/service department.

In the displayed NC block, replace the vocabulary word DC by specifying AC (Absolute Coordinate).

If the alarm display is the result of an error in the axis definition, the axis can be declared as a rotary

axis by means of the axis-specific MD 30300 IS_ROT_AX.

Corresponding machine data:

MD 30310 ROT_IS_MODULO

MD 30320 DISPLAY_IS_MODULO

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16810 Channel %1 block %2 traverse instruction ACP for axis %3 not allowed

Parameters: %1 = channel number

%2 = block number, label

%3 = axis name, spindle number

1 2 ... 177 178 179 180 181 182 183 184 185 186 187 ... 391 392

Siemens SINUMERIK 802D sl Especificações Página 182

Comentários a estes Manuais

Siemens SINUMERIK 802D sl Especificações Página 182

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Siemens SINUMERIK 802D sl