Siemens SINUMERIK 802D sl Especificações descarregar pdf (Página 179)

NCK alarms/ISO alarms

06/2007 Overview of alarms

2-179

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

Remedy: Please inform the authorized personnel/service department. Configure the coupling accordingly in MD

or correct the NC part program (channel MD: COUPLE_AXIS_n).

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

16780 Channel %1 block %2 following spindle/axis missing

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The following spindle/axis has not been written in the part program.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16781 Channel %1 block %2 master spindle/axis missing

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: The master spindle/axis has not been programmed in the part program.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Modify part program.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16782 Channel %1 block %2 following spindle/axis %3 not available

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Axis name, spindle number

Definitions: A coupling has been switched on in which the slave spindle/axis is currently not available. Possible

causes:

- The spindle/axis is active in the other channel.

- The spindle/axis has been accessed by the PLC and has not yet been released.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Please inform the authorized personnel/service department. Put the master spindle/axis with spin-

dle/axis exchange into the necessary channel or release from the PLC.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

16783 Channel %1 block %2 master spindle/axis %3 not available

Parameters: %1 = Channel number

%2 = Block number, label

%3 = Axis name, spindle number

Definitions: A coupling has been switched on in which the master spindle/axis is currently not available. Possible

causes:

- Setpoint linkage has been selected and spindle/axis is active in the other channel.

- The spindle/axis has been accessed by the PLC and has not yet been released.

Reaction: Correction block is reorganized.

Interface signals are set.

Alarm display.

Remedy: Please inform the authorized personnel/service department. Put the master spindle/axis with spin-

dle/axis exchange into the necessary channel or release from the PLC.

Program Con-

tinuation:

Clear alarm with NC START or RESET key and continue the program.

1 2 ... 174 175 176 177 178 179 180 181 182 183 184 ... 391 392

Comentários a estes Manuais

Sem comentários

Siemens SINUMERIK 802D sl Especificações Página 179

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Siemens SINUMERIK 802D sl