Siemens SINUMERIK 802D sl Especificações descarregar pdf (Página 305)

Cycle alarms

06/2007 Overview of alarms

2-305

SINUMERIK 802D sl, Diagnostics Manual, 06/2007 Edition

61286 Channel %1 block %2: machining not possible, check tool angle.

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: Machining not possible with the specified tool.

Alarm triggered by following cycles: F_UCUT_T.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Use a suitable tool.

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61287 Channel %1 block %2: no master spindle active.

Parameters: %1 = Channel number

%2 = Block number, label

Definitions: No master spindle active.

Alarm triggered by following cycle: F_TFS.

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy: Activate the master spindle (machine data 20090).

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61300 Channel %1 Block %2: Probe defective

Parameters: %1 = Channel number

%2 = Block number, label

Definitions:

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61304 Channel %1 Block %2: Allowance

Parameters: %1 = Channel number

%2 = Block number, label

Definitions:

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy:

Program Con-

tinuation:

Clear alarm with the RESET key. Restart part program

61305 Channel %1 Block %2: Dimension too small

Parameters: %1 = Channel number

%2 = Block number, label

Definitions:

Reaction: Interpreter stop

NC Start disable in this channel.

Interface signals are set.

Alarm display.

Remedy:

1 2 ... 300 301 302 303 304 305 306 307 308 309 310 ... 391 392

Comentários a estes Manuais

Sem comentários

Siemens SINUMERIK 802D sl Especificações Página 305

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Siemens SINUMERIK 802D sl