Siemens SINUMERIK 802D sl Especificações descarregar pdf (Página 196)

Overview of alarms 06/2007

NCK alarms/ISO alarms

2-196

SINUMERIK 802D sl, Diagnostics Manual, 06/2007Edition

16956 Channel %1 program %2 cannot be started due to global start disable.

Parameters: %1 = Channel ID

%2 = String (path with program name)

Definitions: The program selected in this channel cannot be started as "Global start disable" had been set.

Note:

PI "_N_STRTLK" sets the "Global start disable" and PI "_N_STRTUL"

deletes the "Global start disable".

The alarm is switched on with $MN_ENABLE_ALARM_MASK bit 6.

Reaction: Alarm display.

Remedy: Delete the "Global start disable" and restart.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

16957 Channel %1 Stop-Delay area is suppressed

Parameters: %1 = Channel ID

Definitions: The program area (Stop-Delay area), which is put into brackets through DELAYFSTON and

DELAYFSTOF, could not be activated. Every stop therefore becomes effective immediately

and is not delayed!

This occurs every time, when braking into a stop Stop-Delay area, i.e. a braking process

starts before the Stop-Delay area and ends not earlier than in the Stop-Delay area.

If the Stop-Delay area is entered with override 0, the Stop-Delay area

can also not be activated (example: a G4 before the Stop-Delay area allows the user

to reduce the override to 0 and the next block in the Stop-Delay area

then starts with override 0 and the alarm situation described occurs.)

$MN_ENABLE_ALARM_MASK Bit-7 switches on this alarm.

Reaction: Interface signals are set.

Alarm display.

Remedy: $MN_STOP_MODE_MASK and language command DELAYFSTON DELAYFSTOF

Program Con-

tinuation:

Alarm display showing cause of alarm disappears. No further operator action necessary.

16959 Channel %1 action %2<ALNX> prohibited during simulation block

search.

Parameters: %1 = Channel number

%2 = Action number/action name

Definitions: The function (2nd parameter) must not be activated during simulation search.

Reaction: Alarm display.

Remedy: Wait for search end.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

16960 Channel %1 action %2<ALNX> prohibited during EXECUTE PROGRAM

AREA.

Parameters: %1 = Channel number

%2 = Action number/action name

Definitions: The function (2nd parameter) must not be activated during EXECUTE PROGRAM AREA.

Reaction: Alarm display.

Remedy: Wait for end of program area EXECUTE.

Program Con-

tinuation:

Clear alarm with the Delete key or NC START.

1 2 ... 191 192 193 194 195 196 197 198 199 200 201 ... 391 392

Siemens SINUMERIK 802D sl Especificações Página 196

Comentários a estes Manuais

Siemens SINUMERIK 802D sl Especificações Página 196

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Siemens SINUMERIK 802D sl