Siemens IEEE802.11 Instruções de Operação descarregar pdf (Página 74)

Configuring with Web Based Management

5.4 "Information" menu

SCALANCE W770/W730 to IEEE 802.11n Web Based Management

74 Configuration Manual, 11/2014, C79000-G8976-C323-03

●

Update on / Update off

WBM pages with overview lists can also have the additional "Update" button.

With this button, you can enable or disable updating of the content area. If updating is

enabled, the display is updated every 2 seconds. To disable the update, click "On".

Instead of "On", "Off" is displayed. As default, updating is always enabled on the WBM

page.

Navigation area (3)

In the navigation area, you have various menus available. Click the individual menus to

display the submenus. The submenus contain pages on which information is available or

with which you can create configurations. These pages are always displayed in the content

area.

Content area (4)

In the navigation area, click a menu to display the pages of the WBM in the content area.

The following is displayed below the picture of the device:

● PNIO Name of Station: PROFINET IO device name

● System Name: System name of the device

● Device Type: The type of the device

● PNIO AR Status: PROFINET IO application relation status

● Power Line1, Power Line2, Power over Ethernet: Status of the power supplies line 1 and

line 2 or power over Ethernet. The power line 2 and power over Ethernet are only

displayed if they are supported by the hardware. You will find further information on this in

the compact operating instructions.

● PLUG configuration: Status of the configuration data on the PLUG

● PLUG license: Status of license on the PLUG

● Fault Status: Error status

Buttons you require often

The pages of the WBM contain the following standard buttons:

●

Refresh the display with "Refresh"

Web Based Management pages that display current parameters have a "Refresh" button

at the lower edge of the page. Click this button to request up-to-date information from the

device for the current page.

Note

If you click the "Refresh" button, before you have transferred your configuration changes

to the device using the "Set Values" button, your changes will be deleted and the

previous configuration will be

loaded from the device and displayed here.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 291 292

Sem comentários

Siemens IEEE802.11 Instruções de Operação Página 74