Siemens IEEE802.11 Instruções de Operação descarregar pdf (Página 260)

Configuring with Web Based Management

5.9 "Security" menu

SCALANCE W770/W730 to IEEE 802.11n Web Based Management

260 Configuration Manual, 11/2014, C79000-G8976-C323-03

Creating new entry

1. In the "IP Address" input box, enter the IP address of the device and in the "Subnet

Mask" input box the corresponding subnet mask.

2. Click the "Create" button to create a new row in the table.

3. Configure the entries of the new row.

4. Click the "Set Values" button to transfer the new entry to the device.

Deleting entries

1. Select the check box in the row to be deleted.

2. Repeat this procedure for every entry you want to delete.

3. Click the "Delete" button. The entries are deleted and the page is updated.

Note

Note that a bad configuration may mean that you can no

longer access the device.

You can then only remedy this by resetting the device to the factory defaults and then

reconfiguring.

5.9.4

Inter AP blocking

5.9.4.1

Basic

Note

•

This tab is available only in access point mode.

•

This WBM page can only be configured with the following KEY-PLUGs:

– W780 iFeatures (MLFB 6GK5 907-8PA00)

–

W700 Security (MLFB 6GK5907-0PA00)

When should Inter AP blocking be used?

The clients connected to an access point can normally communicate with all devices of the

layer 2 network.

With inter AP blocking, the communication of the clients connected to the access point can

be restricted. Only the devices whose IP addresses are configured in "Allowed Addresses"

on the access point are accessible to the clients. Communication with other nodes in the

network is therefore prevented.

1 2 ... 255 256 257 258 259 260 261 262 263 264 265 ... 291 292

Sem comentários

Siemens IEEE802.11 Instruções de Operação Página 260