Siemens IEEE802.11 Instruções de Operação descarregar pdf (Página 216)

Configuring with Web Based Management

5.6 "Interfaces" menu

SCALANCE W770/W730 to IEEE 802.11n Web Based Management

216 Configuration Manual, 11/2014, C79000-G8976-C323-03

With Table 2, you can enable or disable all check boxes of a column of Table 3 (MCS Index)

at once. Table 2 has the following columns:

●

All data rates settings

Shows that the setting is valid for all entries in Table 3.

●

Enabled

In the drop-down list, select the setting for all entries. If "No Change" is selected, the entry

in table 3 remains unchanged.

●

Copy to Table

If you click the button, the setting is adopted for all entries of table 3.

Table 3 (MCS Index) consists of the following columns:

●

Radio

Specifies the WLAN interface to which the information relates.

●

MCS Index

Shows the supported MCS indexes. The displayed MCS indexes depend on the settings

"Antenna Type" and "Antenna Mode". You will find the settings in "Interfaces > WLAN >

Antennas". If, for example, you only use one antenna, only the MCS 0 to 7 are displayed.

●

Streams

Shows the maximum possible number of parallel data streams that can be transmitted

with the selected MCS index.

●

Data Rate [Mbps]

Shows the supported data transmission speeds in megabits per second. The displayed

data transmission speeds depend on the settings "Guard Interval" and "HT Channel

Width". The "HT Channel Width" setting can be found in "Interfaces > WLAN > AP". The

"Guard Interval" setting can be found in "Interfaces > WLAN > 802.11n"

●

Enabled

Enable the option to assign the required data transmission speed to the WLAN interface.

Note

You need to enable at least one MCS index.

Button "Default Values"

The "Default Values" button sets the selection of the values in compliance with the standard.

Procedure

To configure a certain data transmission speed on WLAN 1:

1. For "WLAN 1", select the option "Use selected data rates only".

2. From the "Radio" drop-down list, select the entry "WLAN 1".

3. Select the corresponding check box in the "Enabled" column for the selected MCS index.

4. Click the "Set Values" button.

1 2 ... 211 212 213 214 215 216 217 218 219 220 221 ... 291 292

Comentários a estes Manuais

Sem comentários

Siemens IEEE802.11 Instruções de Operação Página 216

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Siemens IEEE802.11