Siemens Pacemaker UM344-2 Manual do Utilizador descarregar pdf (Página 93)

UM344-2 ON-LINE AND OFF-LINE OPERATION

August 1995

2. Press and hold, for a minimum of 5 seconds, the

FULLSCALE pushbutton, then release the button.

Note the following.

• The "V", "%", and "PB" annunciators shall be lit

and the "PV" annunciator shall be extinguished.

• The displayed number is the VALVE position in

percent (-1 to 110).

• Interpreting a VALVE Open/Close position

depends upon knowing if the FINAL

CONTROL ELEMENT is configured as

REVERSE or DIRECT acting. For DIRECT

acting, 0% indicates a fully closed valve and

100% indicates a fully opened valve. The

opposite is true for a REVERSE acting

controller.

3. Select new VALVE between -1.0% and 110%.

Note the following.

• Cycling (pressing and releasing in less than 1

second) the ZERO or FULLSCALE pushbutton

respectively decrements or increments the

VALVE in 0.01 % increments.

• Pressing and holding either pushbutton, for more

than 1 second, initiates a special acceleration

mode whereby the VALVE changes in greater

and greater increments until limiting occurs.

• The new value is changed in RAM only and not

yet stored permanently in memory. If the

Pushbutton Mode times-out before storage is

accomplished, the Controller will operate with

the new VALVE; however, the new value will

be lost after a power-down or Master Reset.

E. Store New VALVE to Memory (new Power-Up Valve

in Auto Manual Transfer Block)

1. Simultaneously press and release both pushbuttons to

store new VALVE.

After VALVE storage, the Controller exits the

Pushbutton Mode and returns to normal operation.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 182 183

Sem comentários

Siemens Pacemaker UM344-2 Manual do Utilizador Página 93