Siemens Sinumerik 810T Manual do Utilizador descarregar pdf (Página 71)

EMCO WINNC SINUMERIK 810/820 T SURVEY PAGES

G 3

MOVE

not active

NC ALARM

All current NC alarms are displayed.

NC MD

(NC machine data)

The NC machine data are displayed.

OPS

not active

OPT. STOP YES-NO

(Programmed stop ON-OFF)

With „Yes“, the processing of the program is stopped

at the point at which the „M01“ command is

programmed.

OVERR. YES-NO

not active

OVERSTORE

You can change the value of the T, D, S, H, M word

in the buffer memory.

PART PROGRAM

The „PART PROGRAM“ softkey leads to:

• EDIT

• CORR BLOCK

• DIRECTORY

• PROG HANDL

This key is not used to select a program for processing.

After „DATA OUT“, you can select program output

with the softkey „PART PROGRAM“.

PLANE

Select the machining plane in simulation and contour

definition.

PLC ALARM

All current PLC alarms are displayed.

PLC BITS

Display or altering the PLC bits.

PLC M-DATA

not active

PLC MESSAGE

All current PLC messages are displayed

PLC STATUS

The PLC status shows the current state of all inputs,

outputs, flags, timers, counters and data words on

the screen:

• E = Input byte

• A = Output byte

• M = Flag byte

• T = Timer

• Z = Counter

• DB = Data block

• DW = Data word

PROG. HANDL.

(Program handling)

You can copy, rename and delete the program in the

program memory.

PROGRAM CONTROL

(Influencing the program)

The key leads to the following functions:

• SKIP BLOCK

• DRY RUN FEEDRATE

• PROGRAMMED STOP

• RAPID OVERRIDE

• DECODING SINGLE BLOCK

• DRF ENABLE

• DRF HANDWHEEL

PROGRAM END

You select the functions of the „M02“ (end of pro-

gram) group via softkeys.

PROGR. ZO.

(Programmmable zero offset)

Display or entering the zero offset values for G58 and

G59.

RENAME

You can change the program number.

The program itself remains unchanged.

REORG

not active

RESET

Simulation is interrupted and returned to the reset

state.

ROTAT ANGLE

Input of the coordinate rotation for the single zero

offsets G54-G57.

R PARAMETER

After „DATA OUT“, you can select the output of R

parameters with the „R PARAMETER“ softkey.

R PARAMETERS

You input the R parameters as setting data.

SCALE MODIF.

(Scale modification)

Input of setting data for scale modification.

SELECT PROGRAM

Call-up main program or subroutine.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 89 90

Comentários a estes Manuais

Sem comentários

Siemens Sinumerik 810T Manual do Utilizador Página 71

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Siemens Sinumerik 810T