Siemens Sinumerik 810T Manual do Utilizador descarregar pdf (Página 30)

EMCO WINNC SINUMERIK 810/820 T

C 10

OPERATING SEQUENCES

Program Interruption

1. Way

Change to the modes JOG or INC 1 ... INC 10 000.

With these changes no RESET occurs.

The drives will be stopped with holding the

programmed tool path.

Display: HALT: AUTO interrupted

2. Way

Press the key .

The drives will be stopped with holding the

programmed tool path.

Display: HALT: AUTO interrupted

Overstore

The function OVERSTORE changes one or several

values in the intermediate store.

For OVERSTORE the program has to be stopped.

• Press key .

• Extend softkey line (key

) and press softkey

OVERSTORE.

• Now you can enter new values for tool position T,

spindle speed S, auxiliary function H and

miscellaneous function M.

• Press the key , to activate the alterations and

continue the program.

• The program runs with these new values, until in

the program or by repeated OVERSTORE this

values will be altered.

Block Search

With this function you can start a program at any

block.

While block search the same calculations will be

proceeded as with normal program run but the slides

does not move.

• Press the key RESET ( ).

• Select the mode AUTOMATIC.

• Extend displayed softkey line (

) and press

softkey BLOCK SEARCH.

• Enter % for a main program resp. L for a subroutine

and press the key .

• Enter the program number via keyboard and

press the key .

• Enter the block number for the search target via

keyboard and press the key .

• Press the softkey START.

The program blocks will be worked off until the

given search target is reached.

• With the key you can activate the program

run.

Status Display of the PLC

Only on machines with PLC (Programmable Logical

Control) - e.g. PC TURN 50 with tool turret.

• Press softkey DIAGNOSIS

• Press softkey PLC- STATUS

The statii to be displays can be entered directly

e.g.: EB10,H

H hex

B binary

D decimal

The data format (H, B, D) need not to be determined.

If no format is determined the format is like shown in

the table.

Name Address area Remark Format

E 0 - 127 input byte B

A 0 - 127 output byte B

M 0 - 255 marker B

S 0 - 255 S-marker B

DB 0 - 255 data module D

DW 0 - 255 data word* H

Z 0 - 31 counter D

T 0 - 63 time D

*... before DW can be displayed, with DB a data

module has to be selected.

Display of the Software Versions

• Press softkey DIAGNOSIS

• Press softkey SW VERSION

The software version of the control system and the

eventually connected RS 485 devices will be

displayed.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 89 90

Comentários a estes Manuais

Sem comentários

Siemens Sinumerik 810T Manual do Utilizador Página 30

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Siemens Sinumerik 810T