Siemens Sinumerik 810T Manual do Utilizador descarregar pdf (Página 55)

EMCO WINNC SINUMERIK 810/820 T

D 23

PROGRAMMING

Description of Cycles

Cycles will be programmed in the program in a

manner, that first the R parameters will be written into

the program and then the cycle call with the number

of program runs.

Example

N... R20=... R21=... R22=... R24=... R25=...

R26=... R27=... R28=... R29=... R30=...

L95 P2

That means that the cycle L95 with the programmed

parameters will run 2 times.

L93 Cut-in Cycle

The cut-in cycle allows machining of grooves longitu-

dinal, face, outside and inside.

Note:

Both cutting edges of the cut-in tool have to be

measured in neighbouring tool data registers (e.g.:

D21 and D22).

Programming the parameter:

R10 0 for longitudinal, 1 for face cut-in

R21 Outer resp. inner diameter

R22 Start point in Z

R23 Determine the start point

Longitudinal cut-in

1 inside/outside right

-1 inside/outside left

Face cut-in

1 inside right/left

-1 outside right left

R24 Finishing offset in X

R25 Finishing offset in Z

R26 Infeed depth

R27 Width of cut-in

R28 Dwell of the bottom of the cut-in

R29 Angle left flank (0° - 89°)

R30 Radius (+) or chamfer (-) at the bottom left

R31 Cut-in diameter

R32 Radius or chamfer at edge of cut-in left

R33 Radius or chamfer at bottom of cut-in right

R34 Radius or chamfer at edge of cut-in right

R35 Angle right flank

Dimensions for cut-in

R22 R27

R31

R21

R29 R35

R32

R34

R33

R30

R28

R24

R26

R25

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 89 90

Comentários a estes Manuais

Sem comentários

Siemens Sinumerik 810T Manual do Utilizador Página 55

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Siemens Sinumerik 810T