Siemens Sinumerik 810T Manual do Utilizador descarregar pdf (Página 60)

EMCO WINNC SINUMERIK 810/820 T

D 28

PROGRAMMING

L99 Thread Draft

This cycle is for cutting of following threads (longitu-

dinal or face). The single pitches can be different.

Programming the parameter:

R11 Start point of the thread in X absolute

R12 1. intermediate point in X absolute

R13 2. intermediate point in X absolute

R14 End point of the thread in X absolute

R21 Start point of the thread in Z absolute

R22 1. intermediate point in Z absolute

R23 2. intermediate point in Z absolute

R24 End point of the thread in Z absolute

R25 Finishing offset

After automatic cut dividing with roughing oc-

curs a finishing cut with the programmed cut-

ting depth.

R26 Tread let-in, incremental without sign

R27 Tread let-out, incremental without sign

The values R26 and R27 always will be en-

tered parallel to axis without sign. With taper

threads the correct starting and end points will

be calculated automatically.

R28 Number of roughing cuts

R29 Infeed angle (half flank angle)

Flank infeed is only possible with longitudinal

or face threads (no taper threads)

R35 Number of idle cuts

R36 Thread depth (positive value = inside thread,

negative value = outside thread, face thread)

R41 Thread pitch 1

R42 Thread pitch 2

R43 Thread pitch 3Thread draft

R21

R11

R14

R24

R27

R26

R12

R13

R23

R22

R41

R43 R42

R29

R25

R36

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 89 90

Comentários a estes Manuais

Sem comentários

Siemens Sinumerik 810T Manual do Utilizador Página 60

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Siemens Sinumerik 810T