Siemens Sinumerik 810T Manual do Utilizador descarregar pdf (Página 26)

EMCO WINNC SINUMERIK 810/820 T

C 6

OPERATING SEQUENCES

Data Input via COM1 / COM2

• Press softkey DATA IN START. This will start the

receiving function of the software.

• At the right top edge of the screen DIO (Data

Input/Output) will be displayed. Destination signs

the data from the sender (punched tape drive, ...).

• Start the sender.

• With the softkey STOP you can abort the data

input at any time, with DATA IN START you can

restart data input.

• A direct call-up of certain data by the software is

not possible with data input.

Data Import

With the function data import you can load data from

the drives A, B and C.

• Press softkey DATA IMPORT

• Select drive (device for data in)

• Enter below "Mainprogram" resp "Subprogram"

the following program numbers:

Begin: the first program to read in

End: the last program to read in

• Press the softkey MAINPROGRAM or

SUBROUT INE to start reading in the data.

• Transmission of zero offsets, tool data:

Press the softkey START.

• With the softkey STOP you can interrupt the data

input at any time.

Input pattern for data import

WinNC Sinumerik T (c) EMCO

F3 F4 F5 F6 F7

AUTOMATIC

DATA IMPORT

Main program:

Begin: % 0

End: % 0

Subroutine:

Begin: L 0

End: L 0

Device for data in: 1

Device allocation: A= Drive A:

B= Drive B:

C= Program path

TOOL-

OFFSET

ZERO-

OFFSET

MAIN-

PROGRAM

SUB-

ROUTINE

STOP

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 89 90

Comentários a estes Manuais

Sem comentários

Siemens Sinumerik 810T Manual do Utilizador Página 26

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Siemens Sinumerik 810T