Siemens Simatic M7-400 Manual do Utilizador descarregar pdf (Página 127)

100

101

Digital Modules

4-5

S7-400, M7-400 Programmable Controllers Module Specifications

A5E00069467-07

4.2 Sequence of Steps from Choosing to Commissioning

the Digital Module

Introduction

The following table contains the tasks that you have to perform one after the other

to commission digital modules successfully.

The sequence of steps is a suggestion, but you can perform individual steps either

earlier or later (for example, assign parameters to the module) or install other

modules or install, commission etc. other modules in between times.

Sequence of Steps

Table 4-4 Sequence of Steps from Choosing to Commissioning the Digital Module

Step

Procedure Refer To...

1. Select the module Section 4.1 and specific module section from

Section 4.8

2. Install the module in the SIMATIC S7

network

“Installation” section in the manual for the

programmable controller being used:

• S7-400/M7-400 Programmable Controllers,

Hardware and Installation

3. Assign parameters to module Section 4.3 and, if necessary, the specific module

section as of Section 4.7

4. Commission configuration Section on commissioning in the manual for the

programmable controller being used:

• S7-400/M7-400 Programmable Controllers,

Hardware and Installation

5. If commissioning was not successful,

diagnose configuration

Section 4.4

1 2 ... 122 123 124 125 126 127 128 129 130 131 132 ... 637 638

Comentários a estes Manuais

Sem comentários

Siemens Simatic M7-400 Manual do Utilizador Página 127

Comentários a estes Manuais

Manuais e produtos relacionados com Ferramentas de medição e layout Siemens Simatic M7-400