Siemens SIMATIC NET Manual de Serviço descarregar pdf (Página 7)

The Product Spectrum Around the PROFIBUS on Industrial PC

Introduction to PROFIBUS on Industrial PC

C79000-G8976-C068

1 The Product Spectrum Around the PROFIBUS on Industrial

SIMATIC NET communications processors like the CP 5412 (A2) or

CP 5511 form the hardware basis for attaching your personal computer

(PC) or programming device (PG) to PROFIBUS.

The following software products can only be used, if a PROFIBUS

communications processor is installed in your PC or PG. Not every

software package is available for all operating systems and all

PROFIBUS communications processors. Further information about the

possible combinations can be found in the SIMATIC NET catalog

"IK 10" and the product information.

With this software, you can operate the STEP 5 and STEP 7 program

packages via PROFIBUS.

With this software, you can develop and use application programs for

the DP master on your PC or PG.

DP package contains the FDL programming interface, with which you

can develop and use application programs for communication using

layer 2 of PROFIBUS (for example, for communication with the

SIMATIC S5-95).

With this software, you can develop and use application programs for

FMS (layer 7 of PROFIBUS) on your PC or PG.

With this software, you can develop and use application programs for

the S7 protocol (for data exchange with SIMATIC S7 systems) on your

PC or PG.

❏

PROFIBUS CP

Product

Combinations

PG Package

DP Package

FMS Package

S7 Package

1 2 3 4 5 6 7 8 9 10 11 12 ... 35 36

Sem comentários

Siemens SIMATIC NET Manual de Serviço Página 7