Siemens SIMATIC NET Especificações descarregar pdf (Página 116)

106 Siemens Simatic S7 Driver Online Help

[5] Select the PG/PC is the only master on the bus checkbox.

[6] Record the value listed in the Timeout field. You will need this value for

configuring the Power Tool.

[7] Click the SAPI S7 tab and select the Search button. The Search Database

dialog box appears.

[8] Locate the binary connection database you created earlier and click OK to

save your database selection.

[9] Repeat steps 3 to 7 until all your communication processors are defined.

Once SIMATIC NET is configured, you are ready to configure the SI7 driver with the

Power Tool.

[1] Start the Power Tool and select Setup from the Options menu. When the

Power Tool dialog box appears, select the Advanced tab.

[2] Enter the timeout value you recorded earlier in the Global Timeout field. If

you need to change this value in the Power Tool, make sure you adjust the

timeout value in the PG/PC Interface program to match.

[3] Add a channel and select one of the communication processors you listed from

the Communication Processor field.

[4] Select a virtual field device for the selected communication processor from the

Virtual Field Device field.

[5] Enable the channel and add a device.

[6] Select a connection for the device from the Connection field.

[7] Enable the device and add the datablocks you need. Remember to enable each

datablock so that it can communicate with the process hardware.

Using SIMATIC NET v6.0

If you are using SIMATIC NET v6.0, use the following steps to establish

communication with your PLC. When you finish, refer to one of the other topics in

this chapter to configure the SI7 driver.

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 267 268

Sem comentários

Siemens SIMATIC NET Especificações Página 116