Siemens 270 series Instruções de Operação descarregar pdf (Página 102)

Prepare and backup project

7.2 Transfer

TP 270, OP 270, MP 270B (WinCC flexible)

7-10 Operating Instructions, Edition 03/2004, 6AV6691-1DD01-0AB0

Procedure

Proceed as follows:

1. Set the HMI device to "online"

2. Test all the items in the loaded project for which communication with the PLC is

necessary:

– Alarms

– Alarm logging

– Screen selection by PLC through PLC job

– Print functions

7.2.5 Uploading project

Introduction

During transfer, generally only the run-capable configuration (*.fwx) is transferred to the HMI

device. If the original project file is to be used for further development of the configuration or

for fault analysis, it must remain on the configuration computer.

The project and associated source file (*) can be stored on the HMI device. It can be

retrieved (transferred back) if necessary.

After uploading a project, it can be analyzed and modified. This is of particular importance if

• the original configuration computer cannot be accessed, or

• the project source file is no longer available.

Requirements

The following conditions must be fulfilled in order to retrieve a project:

• The HMI device is connected to a configuration computer.

• The associated source file is stored on the HMI device.

• The "Enable Upload" option must be selected in order for the project file to be transferred

from the configuration computer to the HMI device.

This option can be activated in WinCC flexible in "Project > Transfer > Transfer Settings".

• A memory card is inserted in the HMI device.

Downloading and uploading

In the case of transfer, including transfer of the source file, the project file is transferred to

the HMI device.

Following uploading onto the configuration computer, the *.pdz file is compressed by the

WinCC flexible configuration software. The project is then available in HMI format on the

configuration computer and can be edited.

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 273 274

Sem comentários

Siemens 270 series Instruções de Operação Página 102