Siemens ISOLATED MULTI-DROP SG-6048-01 Manual do Utilizador descarregar pdf (Página 21)

The following table shows the points available for mapping in the Siemens

Static Trip III/CPNX overcurrent device:

Static

Trip III/CPNX

Table 9: Siemens Static TRIP III/CPNX Overcurrent Device

NPT

NPA

Unit Description

Amps

Volt

kVA

kWh

kWh-R

kVAR

kQh

Frequency

Power Factor

Line Amps Average

Voltage L-N Average

Voltage L-L Average

kVA (3-phase)

kW (3-phase)

kW Demand

kW Hours

kW Hours Reverse

kVAR (3-phase)

kVAR Hours

Minimum Power Factor

Minimum kW Demand

Maximum Power Factor

Maximum kW Demand

Setpoint Alarm Condition Exists 0-nor, 1-ala

Long-Time Pickup 0-inact, 1-act

Current Unbalance Target 0-nor, 1-ala

Zone Interlock Out (STPU) 0-inact, 1-act

Voltage Unbalance Target 0-nor, 1-ala

Ground Fault Target 0-inact, 1-act

Short Circuit Target 0-inact, 1-act

Long-Time Overload Target 0-inact, 1-act

ST Up Disabled Target 0-inact, 1-act

Static Trip Reset 0-not res, 1-res

ST Local cmd to Trip Breaker 0-inact, 1-act

Instantaneous Bypass Trip 0-inact, 1-act

Under Voltage Target 0-nor, 1-ala

Over Voltage Target 0-nor, 1-ala

Under Frequency Target 0-nor, 1-ala

Over Frequency Target 0-nor, 1-ala

Reverse Power Target 0-nor, 1-ala

1 Network Point Type

2 Network Point Address

Continued on next page . . .

To get the hardware

reference for

mapping points to

CS object attributes

(via the software

model), combine

the NPT (Network

Point Type) and

NPA (Network Point

Address). For

example, the

hardware reference

for the Maximum

Power Factor point

is AI15.

Metasys Integrator—Metasys Integrator Siemens Application 21

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Comentários a estes Manuais

Sem comentários

Siemens ISOLATED MULTI-DROP SG-6048-01 Manual do Utilizador Página 21

Comentários a estes Manuais