
Physical Sensors
Without KNX Connection
Weather sensors
12/10
Siemens ET G1 · 10/2008
■
Technical specifications
Weather sensors specially for AP 257, AP 257/11 and LOGO! weather systems
Type
S 258/02 S 258/03 S 258/13
1)
AP 258/11 AP 258/21 AP 258/31 AP 258/41
Enclosure data
Surface mounting -- -- --
✔ ✔ ✔ ✔
Degree of protection IP65 IP65 IP65 IP65 IP65 IP65 IP65
The following connecting leads must be
used: JY(ST)Y 2 x 2 x 0.6 or PYCYM
2x2x0.6
(can be extended for a max. 20 m)
-- -- --
✔ ✔ ✔ ✔
Dimensions
•Height mm 178 64 64 64 98
•Width mm
58 58 58 64
•Depth mm
38 38 38 38.5
• Diameter of enclosure/impeller mm
35/150 35/150 35/150 -- -- -- --
Mounting type
Mast mountings
✔ ✔ ✔ ✔ ✔ ✔ ✔
5 m fixed cable
✔ ✔ ✔
-- -- --
✔
Wind speed
Detection of current wind speed
✔ ✔ ✔
-- -- -- --
Detection of rotor breakage
✔
-- -- -- -- -- --
Failure monitoring of wind rotor by the
weather system
✔ ✔ ✔
-- -- -- --
Brightness
Measuring range lux -- -- -- 0 ... 255
(dusk)
-- 0 ... 40000
(daylight)
--
Receiving angle
-- -- -- 140° ... 160° -- 140° ... 160° --
Measurement of outdoor brightness
-- -- --
✔
--
✔
--
Temperature
Measuring range °C -- -- -- -- -20 ... +40 -- --
Rain
For the detection and tripping of a switching
signal by rain drops
-- -- -- -- -- --
✔
Two-step heating of sensor areas
(protection against moisture) (fast drying)
-- -- -- -- -- --
✔
Heating voltage generated by weather system
-- -- -- -- -- --
✔
For selection and ordering data, see page 12/11.
1)
The inner diameter of the mast must be 36 mm. No additional mast mount is required. The heating transformer must be ordered separately.
Type Description
M 258 M 258 heating transformers
For S 258 wind rotors, heatable
• Primary voltage 230 V AC
• Secondary voltage 24 V AC
• Fuse 80 mA, slow
• Degree of protection, IP54
• Dimensions (H x W x D): 80 x 120 x 50 mm
M 258/21 M 258/21 mast mountings
Outer diameter 40 mm
• For mounting 2 opposing sensors on a mast with an outer
diameter of 40 mm, for AP 257 weather systems
ET_G1_2009_en.book Seite 10 Freitag, 28. November 2008 9:50 09
Comentários a estes Manuais