Siemens EF 711 Series Guia do Utilizador descarregar pdf (Página 371)

Availability and Session Availability

SCALANCE WLC711

User Guide, V8.11, 07/2012, C79000-G8976-C260-03 12-7

4. Do one of the following:

– For a primary controller, in the Wireless IP Address box, type the IP address of the data

interface of the secondary SCALANCE IWLAN Controller. This IP address must be on a

routable subnet between the two SCALANCE IWLAN Controllers.

– For a secondary controller, in the Wireless IP Address box, type the IP address of the

Management port or data interface of the primary SCALANCE IWLAN Controller.

5. Set this SCALANCE IWLAN Controller as the primary or secondary connection point:

– To set this SCALANCE IWLAN Controller as the primary connection point, select the

Current Wireless is primary connect point checkbox.

– To set this SCALANCE IWLAN Controller as the secondary connection point, clear the

Current Wireless is primary connect point checkbox.

If the Current Wireless is primary connect point checkbox is selected, the specified controller

sends a connection request. If the Current Wireless is primary connect point checkbox is

cleared, the specified controller waits for a connection request. Confirm that one controller has

this checkbox selected, and the second controller has this checkbox cleared, since improper

configuration of this option will result in incorrect network configuration.

6. On both the primary and secondary controllers, type the Detect link failure value.

Note:

Ensure that the Detect link failure value on both the controllers is identical.

7. On both the primary and secondary controllers, select the Synchronize GuestPortal Guest

Users option to synchronize GuestPortal guest accounts between the controllers.

8. From the top menu, click Wireless APs. The SCALANCE IWLAN AP Configuration screen is

displayed.

9. In the left pane, click AP Registration. To set the security mode for the SCALANCE IWLAN

Controller, select one of the following options:

– Allow all Wireless APs to connect — If the SCALANCE IWLAN Controller does not

recognize the serial number, it sends a default configuration to the Wireless AP. Or, if the

SCALANCE IWLAN Controller recognizes the serial number, it sends the specific

configuration (port and binding key) set for that Wireless AP.

– Allow only approved Wireless APs to connect — If the SCALANCE IWLAN Controller

does not recognize the serial number, the Wireless APs will be in pending mode and the

administrator must manually approve them. Or, if the SCALANCE IWLAN Controller

recognizes the serial number, it sends the configuration for that Wireless AP.

Note:

During the initial setup of the network, Siemens recommends that you select the Allow all Wireless APs to

connect option. This option is the most efficient way to get a large number of Wireless APs registered with

the SCALANCE IWLAN Controller.

Once the initial setup is complete, Siemens recommends that you reset the security mode to the Allow only

approved Wireless APs to connect option. This option ensures that no unapproved Wireless APs are

allowed to connect. For more information, see “Configuring Wireless AP Settings” on page 3-19.

10. To save your changes, click Save.

Note:

When two SCALANCE IWLAN Controllers have been paired as described above, each SCALANCE IWLAN

1 2 ... 366 367 368 369 370 371 372 373 374 375 376 ... 491 492

Comentários a estes Manuais

Sem comentários

Siemens EF 711 Series Guia do Utilizador Página 371

Comentários a estes Manuais

Manuais e produtos relacionados com Fogões Siemens EF 711 Series