Siemens GS..D.. Manual do Utilizador descarregar pdf (Página 22)

How to configure an Anybus PROFIBUS Slave module with a Siemens Step7 PLC

SCM-7032-026

Rev 2.1

7 Testing

To verify that the Anybus module and the PLC are correctly configured it is possible to monitor the Input

and Output modules in the Hardware config in the SIMATIC software. An Anybus Communicator with a

loop back dongle at the serial port is used for the test. In the HW Config window, mark the Output module

and open the PLC menu and select Monitor/Modify.

Figure 26 Opening the monitor/modify window.

Then enter a value in the Output module. In this case 45 is entered in the space column Modify value. To

accept press the Modify value button.

www.anybus.com HMS Industrial Networks AB

Page 22 (30)

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28 29 30

Sem comentários

Siemens GS..D.. Manual do Utilizador Página 22