Siemens GS..D.. Manual do Utilizador descarregar pdf (Página 18)

How to configure an Anybus PROFIBUS Slave module with a Siemens Step7 PLC

SCM-7032-026

Rev 2.1

1.5. Communicator configuration

Start the Anybus Communicator Config Tool. The module is configured for PROFIBUS and generic data

mode as shown below. The I/O size is set to 2 bytes in this example.

Figure 19 Bus type setup.

Figure 20 Protocol mode configuration.

The sub network is configured as seen in the figure below. The values are left at the default except for the

update time for the produce transaction, in this case it is set to 500 ms. Also the bit rate is set to 19200 bits/s.

www.anybus.com HMS Industrial Networks AB

Page 18 (30)

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 29 30

Sem comentários

Siemens GS..D.. Manual do Utilizador Página 18