Siemens SINUMERIK 802D sl Manual de Serviço descarregar pdf (Página 98)

Manual machining

5.4 Manual machining using cycles (functions)

Manual Machine Plus Turning

98 Programming and Operating Manual, 06/2009, 6FC5398-6CP10-1BA0

Parameter Description

Angle α Angle of the taper to be machined.

The reference point is either d1 or d2 depending on which dimensioning type is selected.

Max. infeed depth m1 Enter the maximum infeed depth for roughing. The internal infeed calculation ensures that

the infeed is as uniform as possible throughout the roughing operation. This entry value

represents the maximum value possible and is therefore not exceeded.

Finishing

allowance

m2 Finishing allowance in the X axis (m2x)

Finishing allowance in the Z axis (m2z)

The following possibilities exist for the position of the geometry:

Figure 5-58 Roughing cycle E, position "Inside right"

Figure 5-59 Roughing cycle E, position "Outside left"

Sem comentários

Siemens SINUMERIK 802D sl Manual de Serviço Página 98