Siemens Sinumerik 810T Manual de Instruções descarregar pdf (Página 27)

09.91 11 Alarms

11.9 General RESET alarms

Effect:

Remedy:

2048

Circle end point error

• NC START disabled

• Programmed circle end point not on circle

• End point is further away by more than the input limit

in MD

• No geometry in first block of contour subroutine with L95 stock

removal cycle

Correct program

Explanation:

Remedy:

2056

Travel thru transf. center

• Radius axis (linear axis) tends to travel to the zero point of fictitious

coordinate system on the programmed path

• Change cutter radius

• Program different path motion

Significance:

Remedy:

2057

Opt. thread/rev. not available

• A thread has been programmed with G33, G34, G35 although this

function is not implemented in the control

• Feedrate per revolution G95 has been programmed

• Correct program

• Check MD

Explanation:

Remedy:

2058

3D option not available

• 3 axes programmed simultaneously

• Programmed block results in movement of 3 axes

• Correct program, check MD

SINUMERIK 810 GA3/820 GA3 (IA)

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 61 62

Sem comentários

Siemens Sinumerik 810T Manual de Instruções Página 27