Siemens Open Processor Manual do Utilizador descarregar pdf (Página 5)

Document No. 545-461

Installation Instructions

July 30, 2008

11. Push firmly on the free end of the Power Open

Processor/Open Processor so that its C-Bus

card edge and M-Bus connector mate with the

C-Bus connector and M-Bus rail (see

Figure 2). You will hear a “click” when the

Power Open Processor/Open Processor is

properly attached to the mounting rail.

c. A Power Open Processor/Ethernet or

Power Open Processor/BACnet, plug one

end of the RJ-45 connector into the

Ethernet jack box, and the other end into

the corresponding (right-hand) Power Open

Processor port labeled EALN.

NOTE: For smoke control applications

over Ethernet:

You must connect to the Ethernet

ALN or BACnet/IP ALN through an

Ethernet switch UL Listed for Fire

Signaling. The panel and the switch

must be installed in the same room.

12. If the Power Open Processor/Open Processor

needs repositioning, pull the metal latch. Pull

the Power Open Processor/Open Processor

forward from the C-Bus connector (see

Figure 2) and repeat Steps 9 through 11.

13. Plug the pre-wired FLN connectors into the

corresponding ports on the left side of the

Power Open Processor/Open Processor. These

ports are labeled FLN 1, FLN 2, and FLN 3 (see

Figure 3). The screws for the connector should

be pointing down.

15. Discard the temporary connector cover.

WARNING: Open Processor/Protocol

2 or Controller Module - Lithium

Battery

Only qualified service personnel or an

authorized Siemens Building

Technologies, Inc. representative can

enable the Open Processor/Protocol 2 or

Controller Module lithium battery.

Improper installation of battery or use of

a different battery may cause an

explosion.

14. Do one of the following. If you are installing:

a. An Open Processor/Protocol 2, plug the

ALN connector into the corresponding port

on the right side labeled BLN + – S (see

Figure 4). The screws for the connector

should be pointing down.

b. A Power Open Processor/Protocol 2, plug

the ALN connector into the corresponding

(right-hand) port labeled BLN. The screws

for the connector should be pointing down.

16. Enable the Power Open Processor/Open

Processor battery by removing the piece of

Mylar that separates the battery from its holder.

17. Switch the MBC/RBC power switch ON.

The installation is now complete.

Siemens Building Technologies, Inc. Page 5 of 6

1 2 3 4 5 6

Comentários a estes Manuais

Sem comentários