Siemens Open Processor Manual do Utilizador descarregar pdf (Página 3)

Document No. 545-461

Installation Instructions

July 30, 2008

WARNING: Open Processor/Protocol

2 or Controller Module - Lithium

Battery

Only qualified service personnel or an

authorized Siemens Building

Technologies, Inc. representative can

enable the Open Processor/Protocol 2 or

Controller Module lithium battery.

Improper installation of battery or use of

a different battery may cause an

explosion.

c. Power Open Processor/Ethernet or Power

Open Processor/BACnet, plug one end of

the RJ-45 cable into the Ethernet jack box,

and the other end into the corresponding

(right-hand) Power Open Processor port

labeled EALN.

d. For smoke control applications over

Etherne, You must connect to the Ethernet

ALN or BACnet/IP ALN through an Ethernet

switch UL Listed for Fire Signaling. The

panel and the switch must be installed in

the same room.

14. Enable the Power Open Processor/Open

Processor battery by removing the piece of

Mylar that separates the battery from its holder.

13. Discard the temporary connector cover.

15. Switch the MBC/RBC power switch ON.

The installation is now complete.

Figure 1. Temporary Cover with Pre-wired ALN and FLN Connectors Attached.

Figure 2. Installation of the Power Open Processor/Open Processor.

Siemens Building Technologies, Inc.

Page 3 of 6

1 2 3 4 5 6

Sem comentários

Siemens Open Processor Manual do Utilizador Página 3