Siemens RUGGEDCOM RSG2200 Guia do Utilizador descarregar pdf (Página 152)

Chapter 5

Setup and Configuration

RUGGEDCOM ROS

User Guide

140 Configuring the DNP Over Raw Socket Protocol

Section 5.4.13

Configuring the DNP Over Raw Socket Protocol

To configure the DNP Over Raw Socket protocol for a serial port, do the following:

1. Make sure the serial port is configured to use the DNP Over Raw Socket protocol. For more information,

refer to Section 5.4.5, “Configuring a Serial Port”.

2. Navigate to Serial Protocols » Configure Protocols » Configure DNP Protocol » Configure DNP over

RawSocket. The DNP over RawSocket table appears.

Figure 95: DNP over RawSocket Table

3. Select a serial port. The DNP over RawSocket form appears.

Figure 96: DNP over RawSocket Form

1. Port Box 2. Transport Options 3. Call Dir List 4. Max Conns Box 5. Loc Port Box 6. Rem Port Box 7. IP Address Box

8. Link Stats Options 9. Apply Button 10. Reload Button

4. Configure the following parameter(s) as required:

Parameter Description

Port Synopsis: 1 to 4

Default: 1

The port number as seen on the front plate silkscreen on the switch.

Transport Synopsis: { TCP, UDP }

Default: TCP

The network transport used to transport protocol data over the IP network.

Call Dir Synopsis: { In, Out, Both }

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 169 170

Sem comentários

Siemens RUGGEDCOM RSG2200 Guia do Utilizador Página 152