
RSSB Page 71 of 87
GSM-R user procedures (cab radio Version 2)
will lead to a registration failure when coverage is regained as the train may no longer be
at that signal.
Pending registration is not available when you register through the menu.
GSM-R GB
Searching networks
Please wait
Searching networks
1A45 990
Please wait
You can cancel the pending registration state by pressing at any time.
9.3.7 Loss of registration
If the cab radio’s registration is lost at any time, then you must re-register the cab radio at
the first suitable opportunity and report the event to the signaller.
9.3.8 Failure of the cab radio to de-register
GSM-R GB
Deregister failed
1A45 159 Lead Driver
9.3.9 Failure of the Public Address to de-register
The driver can attempt to deregister the ‘stuck PA’ registration using the button. If this
fails, then the fault should be reported to the signaller as a registration failure.
If GSM-R network coverage is not available, the
cab radio will automatically store the registration
code.
After five seconds, the ‘Reg ID saved’ message is
cleared and replaced by a ‘Searching networks –
Please wait’ message. This message will
continue until GSM-R coverage is found, at which
point the cab radio will automatically complete the
registration process.
If the cab radio fails to deregister, first of
all try again. If the cab radio again fails to
deregister contact the signaller (this might
not be possible using the cab radio) and
report the failure.
If the PA fails to deregister and this is not
observed by the driver when closing the
desk, then the next driver to put a driver’s key
on will see the following display.
Then press to attempt to send the
registration code to the GSM-R network.
Comentários a estes Manuais